Toshiba SD-1600, Service Manual

Page: 66 / 125

Fig. 2-1-5
1-1-4. Front Panel and Tray
1. Remove the flexible cable (1).
2. Remove one screw (2) and remove the GND lead (3).
3. Remove 2 cushions (4) at the front panel and remove
two screws (5).
4. Release four claws and remove the front panel (6).
5. Pull out the tray (7).
Fig. 2-1-6
Note:
• Insert the tray (3) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear as shown in the Fig. A,
insert the tray (3). When inserting a tray (3), push the
rack gear side shown by the arrow.
• Confirm that the mark of the gear matches with the
triangle mark on the reverse side of the tray in the tray
close status. (The gear is rotated with the slider locks.)
(Refer to Fig. B.)
Fig. 2-1-7
Tray (7)
Screws (5)
Screw (2)
GND lead (3)
Claw
Claw
Flexible cable (1)
Claws
Front panel (6)
Cushion (4)
A
B
Tray panel (4)
Tray (3)
Tray (3)
Claws Tray panel (4)
Slider
Pickup mechanism
assembly
Tray (3)
Gear (4)
Gear (4)
Triangle mark
Triangle mark
Marking
Gear
Position of the line
Fig. A
Fig. B
The first tooth of the gear of
this side on the tray rack gear.