Figure 4-2 Removing the AccuPoint cap (A30-D)
1
1. AccuPoint cap
Product appearance depends on the model you purchased.
2.
Position a new cap on the peg and press it into place.
The peg is square, so be careful to align the cap’s square hole with
the peg.
You can buy replacement AccuPoint caps from your TOSHIBA
authorized dealer.
Using the Fingerprint Sensor
Some models are equipped with the fingerprint sensor for the purpose of
enrolling and recognizing fingerprints. Follow the on-screen instructions to
finish the setup.
By enrolling the ID and password onto the fingerprint authentication
feature, it is no longer necessary to input the password from the keyboard.
Fingerprint feature enables you to:
Unlock the password-protected screen-saver.
Authentication of the User Password (and, if applicable, the HDD/SSD
Password) when booting up the computer (Pre-Boot authentication).
Single Sign-On feature
Fingerprint cannot be used in models that do not have a fingerprint
function.
How to Swipe your Finger
Using the following steps when swiping fingers for fingerprint registration or
authentication can help to minimize authentication failures:
Align the first joint of the finger to the center of the sensor. Lightly touch the
sensor and swipe finger levelly towards you until the sensor surface
becomes visible. In performing this process, you should also take care to
ensure that the center of your fingerprint is on the sensor.
User's Manual
4-7