4-50
430 Series
6.
Remove the
shielded tape
securing the display cables to the LCD cover.
Figure 4-48 Removing the LCD module (DSTN)
Installing the LCD Module (DSTN)
To install the LCD module, follow the steps below and refer to Figures 4-48 and 4-47.
1.
Secure the display cable to the LCD cover with shielded tape.
2.
Connect the
flexible cable
to
CN-IN
on the
LCD module
.
3.
Connect the
display cables
to
PJ2
,
PJ3
, and
PJ4
on the
flexible cable
.
4.
Carefully rotate the LCD module into the LCD cover. Be sure the flexible cable
fits into the plastic protector.
NOTE
: Support the back of the display with your hand when you secure the
screws.
5.
Secure
four M2.5x6 screws
on the
LCD module
. Make sure the ground cable is
secured at the lower left corner.
6.
Install the FL inverter board, display mask, optional memory module, optional PC
card and battery pack as described in Sections 4.18, 4.16, 4.4, 4.3, and 4.2.