Wireless Remote Controller Kit
Owner’s Manual
– 11 –
8
Handle the Remote Controller
• Point the transmitting part of the remote controller at the signal receiving part of the indoor
unit. When a signal is received normally, “pi” sound is heard once. (“Pi, pi” is heard only at
the beginning of operation.)
• The standard signal receivable distance from the signal receiving part of the indoor unit is
approx. 7 m. The distance varies somewhat with the battery capacity or other conditions.
• Do not put anything that blocks signals between the remote controller and the signal
receiving part of the indoor unit.
• Do not put the remote controller at a place exposed to direct sunlight or air from the indoor
unit or near a heater.
• Do not drop or throw the remote controller or wipe it with water.
• Signals from the remote controller may not be accepted in a room equipped with a rapid
start-type or inverter-type fluorescent light. For details, contact the dealer from whom you
purchased the air conditioner.
To set the Remote Controller on the Wall
• Push
at the installation position on
the wall to check that the signal from the
remote controller is received correctly.
• To take the remote controller out of the
holder, pull it toward you.
9
Notes on Proper Use
• Put the remote controller within the specified distance from the signal receiving part of the
indoor unit.
Failure to do so may result in malfunction.
Be sure to put the remote controller in a room where the indoor unit is installed.
• When pushing a button on the remote controller, point the remote controller at the signal
receiving part of the indoor unit. When the signal receiving part has correctly received a
signal, it emits a “pi” sound.
• Do not put the remote controller behind a curtain or the like.
2
1
Fix the remote controller
holder with screws.
Remote controller
holder
Setting the remote
controller into the holder
Push
Put on.
11-EN
Summary of Contents for RBC-AX23UW-E
Page 16: ...EH72394301 ...
