– 4 –
EN
5
Wired remote control
This remote control can control the operation of up to 8 indoor units.
The remote control has two sections: The display section and the operation section.
Display section
In the display below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When the circuit breaker is turned on the first time,
flashes on the
display part of the remote control.
• While this display is flashing, the model is being automatically confirmed.
Wait till
display has disappeared to use the remote control.
1
SETTING display
Displayed during setup of the timer etc..
2
Operation mode
The selected operation mode is displayed.
3
Check display
Displayed while the protective device works or a
problem occurs.
4
Timer display
When a malfunction occurs, a check code is
displayed.
5
Timer Mode display
Displays the timer mode.
6
Filter display
, reminder to clean the air filter.
7
TEST run display
Displayed during a test run.
8
Set temperature display
The selected set temp. is displayed.
9
Remote control sensor display
Displayed while the sensor of the remote control is
used.
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
Display
section
Operation
section
Partition line
2
12
16
5
7
3
1
4
6
9
11
10
8
1413
15
10
Pre-heat display
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this indication is displayed, the indoor fan
stops.
11
No function display
Displayed when the function requested is not
available on that model.
12
Fan speed display
The selected fan speed mode is displayed.
13
Power saving mode display
Limits compressor speed (capacity) to save
energy.
14
UNIT No. display
Displays the number of the indoor unit selected.
Also displays check code of indoor and outdoor
units.
15
SET DATA
Displayed during advanced setting.
16
Service display
2
12
16
5
7
3
1
4
6
9
11
10
8
1413
15
(AUTO)
(HIGH)
(MED.)
(LOW)
7-EN
8-EN
+01EN02BODY.fm Page 4 Wednesday, June 1, 2016 2:03 PM
