Toshiba XXXXXXX(
X
/X)
– 24 –
4-way Air Discharge Cassette Type
Installation Manual
EN
Change of lighting time of
filter sign
According to the installation condition, the lighting
time of the filter sign (Notification of filter cleaning)
can be changed.
Follow to the basic operation procedure
(
1
→
2
→
3
→
4
→
5
→
6
).
• For the CODE No. in Procedure
3
, specify [01].
• For the [Set data] in Procedure
4
, select the
setup data of filter sign lighting time from the
following table.
To secure better effect of
heating
When it is difficult to obtain satisfactory heating
due to installation place of the indoor unit or
structure of the room, the detection temperature of
heating can be raised. Also use a circulator, etc.
to circulate heat air near the ceiling.
Follow to the basic operation procedure
(
1
→
2
→
3
→
4
→
5
→
6
).
• For the CODE No. in Procedure
3
, specify [06].
• For the set data in Procedure
4
, select the setup
data of shift value of detection temperature to
be set up from the table below.
To select horizontal wind
direction
1. Push
and TEMP.
buttons for at least
four seconds when the air conditioner is not
working.
flashes.
Indicates CODE No. “01.”
2. Select an indoor unit to be set by pushing
button (left side of the button).
Indoor unit number changes each time you
push the button.
The fan of the selected unit runs and the
louvers start swinging.
3. Change the CODE No. to “45” with
TEMP.
buttons.
4. Select wind direction setting with TIME
buttons.
5. Push
button to check the setting.
The display state changes from flashing to
lighting, and the setting is fixed.
6. Push
button to end the setting.
* When the cold draft position is selected, ceiling
contamination is less reduced.
How to set up swing type
1. Push
for at least four seconds when the
air conditioner is not working.
flashes.
Indicates CODE No. “F0.”
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the
louvers start swinging.
Setup data
Filter sign lighting time
0000
None
0001
150H
0002
2500H (At shipment from factory)
0003
5000H
0004
10000H
Setup data
Detection temp shift value
0000
No shift
0001
+1°C
0002
+2°C (At shipment from factory)
0003
+3°C
0004
+4°C
0005
+5°C
0006
+6°C
Wind
direction
setting code
Wind direction setting
0000
Smudge reducing position
(Air direction to reduce ceiling
contamination) [Factory Shipping]
0002
Cold draft position
(Air direction to control cold air fall)
Not
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Not
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
24-EN
+00EH99858901-1_01EN_4-way_IM.book Page 24 Tuesday, June 3, 2008 6:30 PM
