■
Automatic operation
(auto changeover)
This function is available only for use in
combination with a heat recovery model outdoor
unit. If this function is used with another model of
outdoor unit, “A” (Auto) appears on the remote
controller but the automatic operation is disabled.
Start
SWING
FAN
4
3
1
2
1
START/STOP button (
)
Press this button to start the air conditioner.
2
Mode select button (MODE)
Select A.
3
Temperature button (
)
Set the desired temperature.
4
Fan speed button (FAN)
Select one of
LOW , LOW
+
,
MED
, MED
+
, HIGH
.
• The OPERATION lamp on the display panel
of the indoor unit lights.
The operating mode is selected in accordance
with the room temperature and operation starts
after approximately 3 minutes.
• If the “A” mode is uncomfortable, you can select
the desired conditions manually.
Stop
START/STOP button (
)
Press this button again to stop the air conditioner.
CAUTION
Disagreement in operation mode
If you select AUTOMATIC OPERATION in a model
with no auto-changeover (cooling/heating) control
setting or if you select HEAT in a Cool Only model,
lamp lights up and
and
lamps blink
alternately with an alarm sound (pi, pi) from the
air conditioner due to disagreement in operation
mode. Change the operation mode with the MODE
button on the wireless remote controller. This
disagreement indication cannot be deleted by the
wired remote controller.
■
Timer operation
Use the wired remote controller for timer setting if it
is also in use.
ON timer and OFF timer
SWING
FAN
FIX
QUIET
Hi POWER
COMFORT
SLEEP
2
1
3
Setting TIMER
1
ON/OFF TIMER button (
or
)
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and
fl
ashes
along with ON/OFF timer display.
Set the timer to the desired time.
Each press of the TIMER button changes the
time in ten minute steps.
Pressing the TIMER button continually changes
the time in one hour step.
2
SET
button
Press the SET
button to set the timer.
The timer time is indicated and the timer starts.
Cancelling TIMER
3
CLR
button
Press the CLR
button to cancel the timer setting.
CAUTION
• When you select the timer operation, the remote
controller automatically transmits the timer signal
to the indoor unit at the speci
fi
ed time. Therefore,
keep the remote controller in a location where it
can transmit the signal to the indoor unit properly.
Otherwise, the time lag of up to 15 minutes will
occur.
• If you do not press the SET
button within 30
seconds after setting the time, the setting will be
cancelled.
Owner’s Manual
- 19 -
19-EN
OM_1122650210.indd 19
OM_1122650210.indd 19
2/7/21 10:59
2/7/21 10:59
