1
6
Adjustment of wind direction
For best cooling performance, adjust the louvers
(adjustment plates of up / down wind direction)
appropriately. Cold air descends and warm air rises, so
to cool a room tilt them horizontally.
CAUTION
Direct the louvers horizontally for cooling.
If the louvers stay pointed downward during cooling,
condensation may form on the discharge port and /
then drops from the louvers.
• When operation is stopped, the horizontal louver
(plate for adjusting the vertical air
fl
ow) automatically
closes.
◆
How to set up the wind direction
1
Push
during operation.
The wind direction changes for every push of the
button.
In Cool / Dry operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
Initial setup
In Fan operation
Select a desired wind direction.
Initial setup
◆
How to start swinging
1
Push
, set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
again.
SWING
is displayed and the up / down wind
direction is automatically selected.
Display during swinging
Repeat
◆
How to stop swinging
1
Push
at a desired position while the
louver is swinging.
When
is pushed after that, wind direction
can be set again from the highest position.
* However, even if
is pushed while the
louver is swinging, the louver position is
displayed as follows and highest position of the
louver may not be selected.
Display when swinging is stopped
Fan operation
Cool / Dry
operation
In this case, push
again two seconds later.
• In Cool / Dry operation, the louver does not
stop as it directs downward. If stopping the
louver as it directs downward during swing
operation, it stops after moving to the third
position from the highest position.
Display when stopping the swing
Fan operation
Cool / Dry
operation
◆
Unit select button
• When multiple indoor units are controlled with one
remote controller, wind direction can be set for each
indoor unit by selecting individually.
• To set wind direction individually, push
button (left side of the button) to display an indoor
unit number in the control group. Then set the wind
direction of the displayed indoor unit.
• When no indoor unit number is displayed, all
indoor units in the control group can be controlled
simultaneously.
• Each time
button (left side of the button) is
pushed, the display changes as follows:
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Not
display
Horizontal air
fl
ow adjustment
To change the horizontal air
fl
ow direction, point the
vertical louvers inside the horizontal louver in your
preferred direction.
NOTE
• When the horizontal louver is pointing downward in
COOL mode, water droplets may form on the surface
of the cabinet or louver and drop down.
As characteristics of air, cold air
accumulates lower area and warm
air accumulates upper area.
Unit select
button
– 8 –
15-EN
16-EN
1115653808_EN.indd 8
1115653808_EN.indd 8
10/11/2559 BE 16:21
10/11/2559 BE 16:21
