– 31 –
8-4-2. How to Cancel the Auto Restart
Function
To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the
signal and beeps three times.
• When the system is on stand-by (not operating)
• When the system is operating
• While this function is being set, if the unit is in operation, the orange lamp is on.
Operation
Push [TEMPORARY] button for more
than three seconds.
Motions
The unit is on standby.
↓
The unit starts to operate.
The orange lamp is on.
↓
After approx. three seconds,
The unit beeps three times
The lamp changes from
and continues to operate.
orange to green.
If the unit is not required to operate at this time, push [TEMPORARY]
button once more or use the remote controller to turn it off.
TEMPORARY button
0
3S
Operation
Push [TEMPORARY] button for more
than three seconds.
Motions
The unit is in operation.
The orange lamp is on.
↓
The unit stops operating.
The orange lamp is turned off.
↓
After approx. three seconds,
The unit beeps three times.
If the unit is required to operate at this time, push [TEMPORARY]
button once more or use the remote controller to turn it on.
TEMPORARY button
0
3S
8-4-3. Power Failure During Timer Operation
When the unit is in timer operation, if it is turned off
because of power failure, the timer operation is
cancelled. Therefore, set the timer operation again.
NOTE :
The Everyday Timer is reset while a command
signal can be received from the remote controller
even if it stopped due to a power failure.
8-5. Filter Check Lamp
When the elapsed time reaches 1000 hours, the
filter check lamp indicates. After cleaning the filters,
turn off the filter check lamp.
8-5-1. How to Turn Off Filter Check Lamp
Push [FILTER] button on the remote controller.
Or push [TEMPORARY] button on the indoor unit.
Then we have to clarify it.
NOTE :
If [TEMPORARY] button is pushed while the filter
check lamp is not indicating, the indoor unit will start
the automatic operation.
When you want a temporary operation while the filter
lamp lights, put out the lamp once, and then push
the TEMPORARY button.
The unit will be required to be turned on with the
remote controller after the main power supply is
turned off.
Summary of Contents for RAS-13UAV-E
Page 1: ... ILE NO A02 001 SPLIT TYPE RAS 13UKV E RAS 13UAV E PRINTED IN JAPAN Mar 2002 ToMo ...
Page 73: ... 73 MCC 813 ...
Page 78: ......
