Toshiba PORTEGE R300, Maintenance Manual

Page: 85 / 352

2 Troubleshooting Procedures
PORTEGE R300 Maintenance Manual (960-591) [CONFIDENTIAL] 2-43
Procedure 4 Diagnostic Test Program Execution Check
The HDD test program is stored in the Diagnostics Disk. Perform all of the HDD tests in the
Hard Disk Drive Test. Refer to Chapter 3,
Tests and Diagnostics, for more information about
the HDD test program.
If an error is detected during the HDD test, an error code and status will be displayed.
Replace the HDD with a new one following the instructions in Chapter 4,
Replacement
Procedures . The error codes and statuses are listed in Table 2-6. If an error code is not
generated or the problem still exists, go to Procedure 5.
Table 2-6 HDD error code and status
Code Status
01h Bad command error
02h Address mark not found
04h Record not found
05h HDC not reset
07h Drive not initialized
08h Overrun error (DRQ)
09h DMA boundary error
0Ah Bad sector error
0Bh Bad track error
10h ECC error
11h ECC recover enable
12h DMA CRC error
20h HDC error
40h Seek error
80h Time out error
AAh Drive not ready
BBh Undefined error
CCh Write fault
E0h Status error
EEh Access time error
DAh No HDD