Toshiba P9, Installation & Operation Manual

Page: 202 / 306

192 P9 ASD Installation and Operation Manual
Preset Speed 1 Operation Mode
Program

Pattern Run

Operation Mode
This parameter is enabled at F560 and is used to set the speed, torque, and
direction of Preset Speed 1 .
This screen is comprised of 4 fields that are labeled as follows: Direction , Acc/
Dec Group , V/f Group , and Torque Limit Group . Scroll to the field of
interest and press the scroll knob (Enter). Using the scroll knob, set the value
and press the scroll knob (Enter).
Parameters F562 – F575 are used to set the functions listed here for Preset
Speeds 2 – 15 .
When using communications, write the appropriate byte to location F561 as
indicated below.
Settings:
0 — Forward Run
1 — Reverse Run
2 — Accel/Decel Switching 1
4 — Accel/Decel Switching 2
8 — V/f Switching Signal 1
16 — V/f Switching Signal 2
32 — Torque Limit Switching Signal 1
64 — Torque Limit Switching Signal 2
Direct Access Number — F561
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 2 Operation Mode
Program

Pattern Run

Operation Mode
See Preset Speed 1 Operation Mode ( F561 ) for information on this parameter.
Direct Access Number — F562
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
Preset Speed 3 Operation Mode
Program

Pattern Run

Operation Mode
See Preset Speed 1 Operation Mode ( F561 ) for information on this parameter.
Direct Access Number — F563
Parameter Type — Selection List
Factory Default — Forward Run
Changeable During Run — No
F/R
V/f Switch
Torque Limit
Switch 2 A/D Switch
1
2 4 8 16 32 64
0 1 1 0 1 1 0
Writing the following data to location F561 via communications results in:
Forward Run, A/D SW 2, V/f SW 3, Torque Lim SW 4.
{
{
{
{
0=F
1=R
00=A/D 1
01=A/D 2
10=A/D 3
11=A/D 4
00=V/f 1
01=V/f 2
10=V/f 3
11=V/f 4
00=T-Lim 1
01=T-Lim 2
10=T-Lim 3
11=T-Lim 4
F561 F563