75
Connections
Attaching the battery pack
First disconnect the AC adapter and the power cord
from the player, then attach the battery pack.
1 Turn the player off.
2 Turn the player upside down.
3 Open the connector cover on the rear of the
player by pressing it.
4 Turn the battery pack over and matching it to the
line
1
1
1
1
1
on the player. Simultaneously insert the
hooks of the battery pack into the corresponding
holes on the player.
Then, slide the battery pack in the direction of
the arrow
2
2
2
2
2
until a “click” is heard.
Note
Remove the battery pack from the player after being used.
1
2
1
2
1
2
Use a battery pack MEDB02SX (supplied) or MEDB02LX (not supplied). Charge it before using.
Charging the battery pack
1 Turn the player off.
The battery pack will charge only when the POWER
to the player is turned OFF.
2 Attach the battery pack to the player.
3 Connect the supplied AC adapter and the power
cord to the player.
20
Charging starts, and the POWER/CHG indicator
illuminates in orange.
When the charging is completed, the POWER/CHG
indicator turns off.
Notes
• The attached battery pack may get warm when you are
charging it or operating the player. This is not a defect.
• The POWER/CHG indicator flashes in green when the
power in the battery pack is running low.
• Charge the battery with a surrounding temperature of +10
°
C
to +30
°
C.
Charging time of a battery pack
MEDB02SX (supplied)
approximately 5.5 hours
MEDB02LX (not supplied) approximately 7.5 hours
The battery pack can be charged only when the DVD
player is switched OFF. Charging time depends on
environmental conditions.
LCD brightness while using the battery pack
Since the player operates in a power saving mode when
the battery pack is attached, LCD brightness may be
reduced. It can be restored by pressing the DIMMER
button on the remote control. A brighter LCD display will
shorten battery pack life.
Continuous playback time while using the
battery pack
MEDB02SX (supplied)
up to approximately 3.5 hours
MEDB02LX (not supplied) up to approximately 5.5 hours
(Conditions: 25
°
C, output from the speakers, LCD
brightness minimized, new battery pack in use.)
• Continuous playback time may vary depending on
battery pack status, operational status and
environment conditions.
• Low temperature will shorten the playback time.
Warning
• Do not use a battery pack other than one specified as it can result in a fire or damage to the unit.
• Do not heat, open, or short-circuit the battery pack. Do not throw the battery pack into a fire. Doing so may cause an
explosion or a fire.
• Attach the battery pack properly following the explanation below. Make sure that the battery pack is attached firmly to
the player when using it. Otherwise, the battery pack may become detached and cause personal injury.
Open the
connector cover
Battery pack
Match to line
1
Using the Battery Pack
Summary of Contents for P2000 - DVD Player - 8.9
