– 7 –
Operation section
Once the settings have been configured, all you need to do is push the
button from then on.
1
button (Fan speed select button)
No function.
2
button (Timer set button)
Use to setup the timer.
3
button (TEST button)
Use only for service.
(During normal operation, do not use this button.)
4
button
No function.
5
button (Filter reset button)
No function.
6
button (Power save operation)
No function.
7
button
No function.
8
Operation lamp
Lights up during running.
Blinks when an error occurs or the protective
device activates.
9
button
Turns on the unit when pushed, and turns off when
pushed again.
10
button (Operation mode select button)
Heating mode is only available. Only heating
symbol is displayed.
11
button (Unit / Louver select button)
UNIT button:
No function.
LOUVER button:
No function.
12
button
Adjusts the set temperature.
Select the desired set point by pushing TEMP.
or TEMP.
OPTION:
Remote controller sensor
Do not use “Remote controller sensor”.
1 8
3
5
2
9
10
6
7
12
4
11
SWING/FIX
UNIT LOUVER
4
Basic operation
When you use the hot water module for the first time or change the settings, follow the procedures below.
From next time, pushing the
button starts running of the hot water module with the chosen settings.
Preparation
Turn on the power switch
• When turned on, the separation line appears and
blinks on the remote controller display.
* The remote controller will not work for about 1 minute after turning on the power. This is not a
malfunction.
REQUIREMENT
• Keep the power switch turned on during use.
• When you resume using the hot water module after a long period of disuse, turn on the power switch at least
12 hours before starting running.
Operations
1
Push the
button.
The operation lamp lights up.
2
Push the “MODE
” button to select a
operation mode.
Only heating symbol is displayed. Heating mode is
only available.
3
Push the
button to stop running.
The operation lamp turns off.
Changing the set temperature
1
Push the “TEMP.
” buttons.
Push
to increase the temperature, and
to
decrease the temperature.
Heating
SET
TIME
TIMER SET
TEST
FILTER
RESET
TEMP.
CL
FAN
SAVE
SWING/FIX
VENT
MODE
ON / OFF
UNIT LOUVER
1
2
Operation mode
Setting range
Factory default
HEAT
25 to 50 °C
35 °C
13-EN
14-EN