13
3-4. Correct Usage
When you use the air conditioner for the first time or when you change the SET DATA value, follow the proce-
dure below. From the next time, the operation displayed on the remote controller will start by pushing the
ON / OFF
button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
* After the power supply is turned on, the remote controller does not accept an operation for approx. 1 minute,
but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
ON / OFF
button without turning off the main power
switch and the leak breaker.
1
Push
ON / OFF
button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the “MODE
MODE
” button.
One push of the button, and the display
changes in the order shown on the right.
• In HEAT
mode, if the room temperature reaches to
the set temperature, the outdoor unit stops and the air
flow becomes ULTRA LOW and the air volume decreases.
• In the heating mode, the fan stops so that cool air is not discharged and Heat
is displayed.
3
Select air volume with “FAN
FAN
” button.
One push of the button, and the display
changes in the order shown on the right.
• When air volume is “AUTO
”, air volume differs according to the temperature difference between set
temp. and room temp.
• In DRY
mode, “AUTO
” is displayed and the air volume is LOW.
• In heating operation, if the room temperature is not heated sufficiently with VOLUME “LOW
” operation,
select “MED.
” or “HIGH
” operation.
4
Determine the set up temperature by pushing the “TEMP.
” or “TEMP.
” button.
Stop
Push
ON / OFF
button.
The operation lamp goes off, and the operation stops.
1
3
2
4
ON / OFF
FAN
TEMP.
SWING/FIX
TIME
MODE
VENT
UNIT
SET
CL
FILTER
RESET TEST
TIMER SET
Heat-pump model
DRY
COOL
FAN
Cooling only model
(Dehumidity)
AUTO
HEAT
DRY
COOL
FAN
LOW
MED.
HIGH
AUTO
