14
3.2 System Information
You can display system settings information as shown on
Table 3.2 A
below at any time by pressing
the
DISPLAY
button . However, when the unit is displaying a decoded image from a multiplexer, you
must first switch the unit to encoded image displaying (The pictures is switching swiftly and the light
of
MUX/ DVR
button is off) by pressing the
MUX/ DVR
button . Each sequential press of the
DISPLAY
button displays a different message detailed in the following example. By default, the unit
displays time, date, and an indicating bar of capacity status on a monitor as shown next.
Default display
(Capacity Used)
(Capacity Remaining)
09- 05-2001
16:13:02
(Date)
(System Time)
Press the
DISPLAY
button once; the unit will display the following sample message plus the default
display. Press the
DISPLAY
button again; the unit will not display any OSD message. Press the button
one more time to back to the default display.
Table
3.2
A.
Description
of
Table
3.2
A
(HD1+HD2: 76GB):
Total capacity of installed hard disk, 76 GB
(11.2 HR):
Total 11.2 hour minimum guaranteed recording
time available. Actual recording time may be
longer in everyday use.
(
):
Timer record activated
(
):
Alarm record activated
(QUALITY: HIGH):
Record quality setting, HIGH
(NTSC):
NTSC system
(RATE: 6 HR):
Setting of Record time mode, 6 hours
(20 F/S):
Record speed setting, 20 fields/sec
(HD):
Hard disk Compartment
(P): Y
Hard disk installed;
.
No hard disk installed
(SIZE 38GB):
The capacity of the installed hard disk
POS:
Percentage of system;
R:
Recording;
P:
Playback
HD 1+HD 2: 76G
11.2 HR
QUALITY: HIGH
NTSC
RATE: 6 HR
20 F/S
HD P SIZE
POS
1
Y
38 G
2.5%R (P)
2
Y
38 G
0%R (P)
3 . .