Toshiba JTNI6 Series, Instruction Manual, Page: 27 / 50

4.2 Installation
Unified Controller TC-net 100 PCI express Card JTNI6 Instruction Manual
15
4.2 Installation
Follow the steps below to install the card.
(1) Remove the front panel if necessary.
For details, refer to the instruction manual of the PC which you are installing
the card to.
(2) Remove the computer cover.
For the procedure of removing the computer cover, refer to the instruction
manual of the PC which you are installing the card to. Be sure to observe the
following.
DANGER
• Before removing the computer cover, pull out the power plug.
Touching the live parts inside could cause electric shock.
(3) Installing the card
Install the card as described below.
CAUTION
• Do not touch the heat sink of the CPU.
The heat sink is still hot after switching power off, possibly
causing burns.
Important
 To install an extension board, take adequate measures against static (by wearing gloves, for
example).
Note
 The extension slot is subject to restrictions on current capacity. Before installing an extension
board, check that its rated current does not exceed the current capacity of your personal
computer.
To install the extension card, follow the procedures below.
Remove the screw (M3x6) that
fastens the mask panel, then remove
the mask panel. Keep the removed
mask panel with care
Mask panel