13
Hardware Installation
S/N: A1510XXXX
MAC: 0002D1XXXXXX
Operating environment
12V DC, PoE+(IEEE802.3at) : -30°C ~ +50 °C (- 22°F ~ 122 °F)
PoE(IEEE802.3af): -10 °C ~ +50 °C (14 °F ~ 122 °F)
l
The built-in heater does not work with PoE(IEEE802.3af).
l
When the camera is installed and operated in low temperatures below –10 °C {14
°F}, normal images may not be obtained immediately after startup. In such a case,
wait until the camera warms up (taking more than 1 hour) and start adjustment after
turning on the power again.
NOTE
Record the MAC address under the camera base
before installing the camera.
Tamper-proof screws
First, use the supplied torx driver to loosen the four screws and detach the dome cover from the
camera base. Then, follow the steps below to install the camera to either a ceiling or a wall.
Bottom of the camera
