User’s Manual
EN-13
TOSHIBA FOLIO 100
Turning off the power
The power can be turned off in one of two modes, either Shut Down Mode
or Suspend Mode. You can also turn the LCD off in order to extend the
battery life.
Shut Down Mode
When you turn off the power in Shut Down Mode no data will be saved and
the device will boot to the operating system’s main screen the next time it is
turned on.
1. If you have entered data, either save it to flash memory or to other
storage media.
■
Select
Power off
from the Device options menu.
2. Turn off any peripheral devices connected to the TOSHIBA FOLIO 100
device.
Suspend Mode
If you have to interrupt your work, you can turn off the power without exiting
from your software by placing the device into Suspend Mode.
Executing Suspend Mode
You can enter Suspend Mode in one of the following ways:
■
Select
Suspend
from the Device options menu.
■
Press the power button.
When you turn the power back on, you can continue where you left when
the system went into Suspend mode.
Resuming from Suspend Mode
You can resume from Suspend Mode in the following way:
■
Press the power button again.
■
Never turn off the power while an application is running. Doing so could
cause loss of data.
■
Never turn off the power, disconnect an external storage device or
remove storage media during data read/write. Doing so can cause data
loss.
■
In any emergency case, you can also press the power button for about
six seconds to force power off.
Do not turn the device or peripheral devices back on immediately - wait a
short period to avoid any potential damage.
■
Before entering Suspend Mode, be sure to save your data.
■
Do not remove the battery pack while the device is in Suspend Mode
unless the device is connected to an AC power source. Data in
memory could be lost.
