Toshiba ESTIA A09-01P, Quick Reference

Page: 23 / 31

Quick Reference Guide - Page 23
) Setting Hot Water Temperature Range (function code 18 to 1F)
ot water.
tion code 20 and 21)
rature. It
ction code 24 and 25)
rature when the hot water
T WATER BOOST
Main setting items
(1
• Set the temperature range for heating (zone 1, zone 2), cooling, and h
• The upper-limit and lower-limit temperatures of each mode can be set.
) Setting Heat Pump Operation Conditions for Hot Water Supply (func (2
• Set the heat pump start water temperature and heat pump stop water temperature.
rt water tempe • The heat pump starts working when the water temperature lowers below the set sta
is recommended that the default value be used.
3) Compensating Hot Water Temperature (fun (
• Compensate the target temperature from the remote controller set tempe
temperature lowers below the set outside air temperature.
4) Setting Hot Water Boost (function code 08 and 09) (
• Set the control time and target temperature when the HO button on the remote
ria
water cylinder when ANTI BACTERIA
controller is pressed.
5) Setting Anti-Bacte (
• Set the control for the hot is set with the remote controller.
ation), a
s the preferred operation mode.
rature.
oiler output is
ing Heating Auto Mode Temperature (function code 27 to 31)
ting on the remote controller.
0°C.
• Set the target temperature, control period, start time (24-hour not nd target temperature retention
period.
this control setting according to regulations and rules of respective countries. • Make
6) Setting Priority Mode Temperature (
• Set the outside air temperature that change
• Hot Water - Heating Switching Temperature
temperature lowers the set tempe Heating operation takes precedence when the
• Boiler HP Switching Temperature
t temperature, the HP operation stops and the external b When the temperature lowers the se
made.
7) Sett (
• Compensate the target temperature when Auto is set for temperature set
• The outside air temperature can be set to one of three points (T1, T2, and T3) within a range of -20 to 2
• The target temperature can be set to a value from 20 to 55°C.
• However, A > B > C > D > E.
• The entire curve can be adjusted plus and minus 5°C by function code 27.
) Setting Frost Protection Temperature (function code 3A to 3B) (8
button on the remote controller is pressed.
t w
en the FROST PROTECTION
• Set the function when the FROST PROTECTION
• Set enabling/disabling of this function and the targe
ater temperature.
• If disabling is set, the frost protection operation is not performed even wh button
Frequency of Output to Internal Heater (function code 33 to 34)
ler function code 0F to 11)
is pressed.
(9) Setting
• The increase/decrease time is used to set the response time.
10)Setting Night Setback (function code 26. remote control (
• Set the function when the NIGHT button on the remote controller is pressed.
ion, re e. • Set enabling/disabling of this funct duction temperature, start time, and end tim
• If disabling is set, the night setback operation is not performed even when the NIGHT button is pressed.