Toshiba e-studio 202L, Service Manual, Page: 140 / 354

e-STUDIO200L/202L/230/232/280/282 CONTROL PANEL June 2004 © TOSHIBA TEC
5 - 6
65 Updated the template set-
ting Displayed when the template stored
is recalled by pressing [TEMPLATE]
button
66 Enter Department Code Displayed when a button is pressed
while the department management
setting is available
67 Cannot copy
Check DEPARTMENT
COUNTER Displayed when the number of print-
outs exceeds the limit number of
department counter
68 Not enough memory to
store original(s)
Will you print out stored
originals? Displayed when confirming the user
to print out the data as much as
stored at memory-full state
69 Not enough memory to
store original(s)
Will you enable stored orig-
inals? Displayed when confirming the user
to send the FAX data as much as
stored at memory-full state Displayed only in FAX Function
70 Not enough memory to
store original(s)
Will you save stored origi-
nals? Displayed when confirming the user
to save the scanning data as much
as stored at memory-full state Displayed only in Scanning Function
71 The number of originals
exceeds the limits Will you
copy stored originals? Displayed when confirming the user
to print out the data as much as
stored at memory-full state
72 The number of originals
exceeds the limits.
Will you enable stored orig-
inals? Displayed when confirming the user
to send the FAX data as much as
stored at memory-full state Displayed only in FAX Function
73 The number of originals
exceeds the limits.
Will you save stored origi-
nals? Displayed when confirming the user
to save the scanning data as much
as stored at memory-full state Displayed only in Scanning Function
74 Install new toner cartridge No toner in the cartridge Displayed when toner is running out.
Copying not enabled
75 Time for periodic mainte-
nance PM cycle
•
Displayed at the time for mainte-
nance
• Copying is available
Maintenance and inspection are per-
formed by qualified service techni-
cian
76 Please try again after a
while Displayed when the Department
Code can no be keyed in immedi-
ately after power-ON. Leave it for a while and key in the
code again
77 Misfeed in copier Paper jam in the equipment
•
Displayed when paper jam
occurred in the equipment
Remove the paper in the equipment
according to the messages displayed
on the panel
78 Call for service Displayed when motor, sensor,
switch, etc. do not work properly Turn OFF the power and solve the
problem, then turn ON the power.
79 Cannot use envelope Displayed when envelope cannot be
set for duplex copy Re-set
80 Size must be ENVELOPE;
Type is ENVELOPE Displayed when envelope is set for
media type, but not for the size of the
paper Re-set the paper size
81 Type must be ENVELOPE;
Size is ENVELOPE Displayed when envelope is set for
the size of the paper, but not for the
media type Re-set the media type
82 Press START button to
copy after changing setting Displayed when the build job is set
No. Message State of equipment Note