Toshiba e-studio 202L, Service Manual, Page: 123 / 354

4
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 GENERAL OPERATION
4 - 5
4.2.4 Bypass feed copying
1) Insert a sheet of paper into the bypass tray.
!"
Bypass paper sensor ON
- “Ready for bypass feeding” is displayed.
2) Press the [START] button
!"
“Ready for bypass feeding” changes to “COPYING”
!"
Exposure lamp ON
!"
Scan motor ON
$
Carriages -1 and -2 move forward
!"
Polygonal motor rotates in high speed
!"
Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
3) Bypass feeding
!"
Main charger, developer bias and discharge LED ON. Fans are rotated in high speed.
!"
Bypass feed clutch ON
- The bypass pickup roller start to rotate.
- The bypass pickup roller is lowered.
- The bypass feed roller start to rotate.
!"
Aligning operation
!"
Paper reaches the registration roller
!"
After a certain period of time, the bypass feed clutch OFF
4) Hereafter, the operation 3) through 6) of
!
P.4-3 "4.2.3 Drawer feed copying (Upper drawer paper
feeding)" is repeated.
4.2.5 Interruption copying
1) Press the [INTERRUPT] button
!"
LED “INTERRUPT” ON
!"
Copying operation in progress is temporarily stopped. Carriages -1 and -2 return to appropriate
positions.
!"
“Job interrupted job 1 saved” is displayed.
!"
Automatic density and reproduction ratio 100% are set (The set number remains the same)
2) Select the desired copy condition
3) After the interruption copying is finished:
!"
LED “INTERRUPT” OFF by pressing the [INTERRUPT] button
!"
Equipment returns to the status before the interruption
!"
“Ready to resume job 1” is displayed
4) Press the [START] button
!"
The copying operation before the interruption is resumed.