12
EN
Installing Batteries in the Remote
Control
Install 2 R6 (1.5 V) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• The maximum operable range as follows:
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
equipment located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
Switching DVD / VHS mode
You must select which component you want to operate first.
Press
[DVD]
or
[VCR]
on the remote control or the front
panel.
Press
[DVD]
on the remote control.
Press
[VCR]
on the remote control.
Note
• You can also press
[SELECT]
on the front panel to switch
between DVD and VHS mode.
About the Remote Control
Line of sight:
approximately 7 m
Either side of centre:
approximately 7 m within 30 degrees
2
1
3
VCR
DVD
Within
about 7 m
7 m (30°)
7 m
7 m (30°)
DVD
VHS
VCR
DVD
PROGRAM
DUBBING
SELECT
DVD
DVD
VCR
VCR
USB
DV IN
SELECT
DVD
VCR
Device select indicators
indicator
DVD button
VCR button
button
E9TK5FD_EN.book Page 12 Wednesday, January 13, 2010 10:33 AM