Direct Access Parameter Information
https://www.toshiba.com/tic/
83
Preset Speed 6
Program
Frequency
Preset Speeds
This parameter assigns an output frequency to binary number
0110 and is identified as Preset Speed 6. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
for additional information on this parameter.
Direct Access Number —
F023
Parameter Type —
Numerical
Factory Default —
0.00
Changeable During Run —
Yes
Minimum — Lower-Limit Freq.
Maximum — Upper-Limit Freq.
Units — Hz
Preset Speed 7
Program
Frequency
Preset Speeds
This parameter assigns an output frequency to binary number
0111 and is identified as Preset Speed 7. The binary number is
applied to S1 – S4 of the Terminal Board to output the Preset
Speed.
for additional information on this parameter.
Direct Access Number —
F024
Parameter Type —
Numerical
Factory Default —
0.00
Changeable During Run —
Yes
Minimum — Lower-Limit Freq.
Maximum — Upper-Limit Freq.
Units — Hz
Summary of Contents for DN-68249-003
