224
https://www.toshiba.com/tic/
Direct Access Parameter Information
Communication Option (DeviceNet/Profibus) Setting 2
Program
Communications
Communication Options
While using the DeviceNet/Profibus communications protocol,
parameters
allow the user to select the ASD mem
-
ory location that holds the Command/Frequency/Monitoring
instructions to be applied to the ASD for Communications Option
Settings 2 – 9, respectively.
See the DeviceNet Option Instruction Manual (P/N 58683) for
additional information on this parameter.
Direct Access Number —
F831
Parameter Type —
Numerical
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 3
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F832
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 4
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F833
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 5
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F834
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 6
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F835
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 7
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F836
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 8
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F837
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Communication Option (DeviceNet/Profibus) Setting 9
Program
Communications
Communication Options
for information on this parameter.
Direct Access Number —
F838
Parameter Type —
Selection List
Factory Default —
0000h
Changeable During Run —
Yes
Summary of Contents for DN-68249-003
