Direct Access Parameter Information
https://www.toshiba.com/tic/
155
(Virtual Linear Pump) Transducer Maximum Reading
Program
Virtual Linear Pump
Settings
During a properly configured Virtual Linear Pump operation, this
parameter establishes the maximum level of the transducer
range for Virtual Linear Pump operation.
Direct Access Number —
F393
Parameter Type —
Numerical
Factory Default —
0.0
Changeable During Run —
Yes
Minimum — -3276.7
Maximum — 3276.7
Virtual Linear Pump Minimum (Threshold)
Program
Virtual Linear Pump
Settings
During a properly configured Virtual Linear Pump operation, this
parameter establishes the minimum setpoint within the Virtual
Linear Pump operating domain.
Direct Access Number —
F394
Parameter Type —
Numerical
Factory Default —
10
Changeable During Run —
Yes
Minimum — 10
Maximum — Virtual Linear Pump
Maximum Setting (
Virtual Linear Pump Maximum (Threshold)
Program
Virtual Linear Pump
Settings
During a properly configured Virtual Linear Pump operation, this
parameter establishes the maximum setpoint within the Virtual
Linear Pump operating domain.
Direct Access Number —
F395
Parameter Type —
Numerical
Factory Default —
10
Changeable During Run —
Yes
Minimum — Virtual Linear Pump
Minimum Setting (
Maximum — 165
Virtual Linear Pump Command Source
Program
Virtual Linear Pump
Settings
During Direct mode or the Process Hold mode operation, this
parameter sets the Virtual Linear Pump command source.
Settings:
0 — EOI
1 — *V/I
2 — RR
3 — Communication Board
Note: *If Process Hold is selected at
, selecting V/I here will
result in an error message.
Direct Access Number —
F396
Parameter Type —
Selection List
Factory Default —
EOI
Changeable During Run —
No
Summary of Contents for DN-68249-003
