110
https://www.toshiba.com/tic/
Direct Access Parameter Information
RR Input Point 1 Frequency
Program
Frequency
Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR input
terminal when the RR terminal is used as the control input while
operating in the Speed Control mode.
This parameter sets RR Input Point 1 Frequency and is the fre
-
quency that is associated with the setting of RR Input Point 1 Set
-
ting when operating in the Speed Control mode.
See RR Input Point 1 Setting (
) for additional information on
this parameter.
Direct Access Number —
F211
Parameter Type —
Numerical
Factory Default —
0.00
Changeable During Run —
Yes
Minimum — 0.00
Maximum — Maximum Freq.
(
Units — Hz
RR Input Point 2 Setting
Program
Frequency
Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR input
terminal when the RR terminal is used as the control input while
operating in the Speed Control mode or the Torque Control
mode.
This parameter sets the RR input level that is associated with RR
Input Point 2 Frequency
when operating in the Speed control
mode or is associated with the RR Input Point 1 Rate when oper
-
ating in the Torque Control mode.
This value is entered as 0% to 100% of the RR input signal
range.
See RR Input Point 1 Setting (
) for additional information on
this parameter when used for Speed control.
See RR Input Point 1 Rate (
) for additional information on
this parameter when used for Torque Control.
Direct Access Number —
F212
Parameter Type —
Numerical
Factory Default —
100
Changeable During Run —
Yes
Minimum — 0
Maximum — 100
Units — %
RR Input Point 2 Frequency
Program
Frequency
Speed Reference Setpoints
This parameter is used to set the gain and bias of the RR input
terminal when the RR terminal is used as the control input while
operating in the Speed Control mode.
This parameter sets RR Input Point 2 Frequency and is the fre
-
quency that is associated with the setting of RR Input Point 2 Set
-
ting when operating in the Speed Control mode.
See RR Input Point 1 Setting (
) for additional information on
this parameter.
Direct Access Number —
F213
Parameter Type —
Numerical
Factory Default —
(ASD-Depen
-
dent)
Changeable During Run —
Yes
Minimum — 0.00
Maximum — Maximum Freq.
(
Units — Hz
Summary of Contents for DN-68249-003
