1-6-2
E9NG0DC
Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2).
1-3. Disconnect Connector (CN1231) and remove the
Panel Front.
2. When reassembling, solder wire jumpers as shown
in Fig. D8.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on BOARD AV as shown in
Fig. D8. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D8.
4. The DVD Mechanism & DVD Main BOARD
Assembly is adjusted as a unit at factory.
Therefore, do not disassemble it.
Replace the DVD Mechanism & DVD Main
BOARD Assembly as a unit.
(S-1)
(S-1)
(S-1)
(S-1)
(S-1)
[1] Cover Top
Fig. D1
(S-3)
(S-3)
(L-1)
(L-2)
(L-1)
(S-4)
(S-3)
(S-2)
CN1231
(L-1)
Fig. D2
Front
Support
[2] Panel
Front
[3] Front Bracket
Fig. D3
(S-5)
Jack Plate Earth
[4] Jack Bracket
[5] BOARD
Front Jack