11/15
J1 Connector
Interface Cable
6. Insert the Antenna Cable into the connector of the RFID R/W Module.
7. Insert the other side of the connector of the Interface Cable into the J1 Connector of
the Main PCB.
Main PCB
RFID R/W Module
8. By paying attention so as not to catch the cables, attach the Front Panel and the Side
Cover (L) in the reverse procedure of the removal.
Side Cover (L)
Front Panel
9. The installation of the RFID kit in the printer is now completed. Perform various
settings related to the RFID in the System Mode of the printer.
Antenna Cable
RFID R/W Module
12/15
4.
RFID MODULE SETTINGS
After installing the RFID Module in the printer, set various settings related to the RFID in the
System Mode of the printer.
■
How to enter the System Mode
SYSTEM MODE
Press
[ENTER].
■
Contents of the RFID Menu
Menu
Sub menu
Parameter
RFID TEST
ID
READ
MODULE MODULE
TYPE
COUNTRY
TAG
RF CHANNEL
RETRY ADJ RETRY POSITION
ISSUE RETRY LABELS
READ RETRY
WRITE RETRY
UHF SETTING
POWER LEVEL
Q VALUE
AGC THRESHOLD
WRITE AGC THRESHOLD
WRITE RETRY MIN AGC
OTHER
TAG CHECK
MULTI WRITE
CARRIER SENSE
These items cannot be set in this kit.
■
Key functions in the system mode
Key
Function
[MODE]
Returns to the mode menu screen.
[CANCEL] or
[FEED]+[RESTART]
Returns to the upper hierarchy.
[ENTER] or [PAUSE]
Displays a next screen.
Saves the setting and returns to the upper hierarchy.
[UP] or [RESTART]
Moves the cursor upward.
Increases a value.
[DOWN] or [FEED]
Moves the cursor downward.
Decreases a value.
[LEFT]
Moves the cursor to the left.
[RIGHT]
Moves the cursor to the right.
Turn on the printer while holding
down
[FEED]
&
[PAUSE]
or
[MODE].
Power OFF
<1>DIAG.
<2>PARAMETER SET
<3>ADJUST SET
<4>TEST PRINT
Press
[DOWN]
until “<10>RFID”
is highlighted.
<7>INTERFACE
<8>BASIC
<9>FOR FACTORY
<10>RFID
SYSTEM MODE
