2
2.
Attach the assembled Supply Holder Frame to the rear of the B-852 printer by inserting the hooks of the
Frame into the two slots in the rear of the printer as shown in the figure below.
1.2 Installing the Media onto the Supply Holder Unit
1.
Disassemble the Supply Holder Unit.
1) Position the Supply Holder Unit as shown in the above diagram so that the Non-removable Supply Holder
is at the right.
2) Rotate the Green Supply Holder Locking Knob in the direction of arrow
(counterclockwise) to loosen
the Removable Supply Holder.
3) Slide the Removable Supply Holder in the direction of arrow
to remove it from the Supply Shaft.
4) Rotate the green Supply Holder Locking Knob in the direction of arrow
(counterclockwise) to loosen
the Non-removable Supply Holder.
5) Slide the Non-removable Supply Holder all the way to the end of the Supply Shaft until it stops.
Hook
Hook
NOTE
:
After attaching the supply holder frame to the printer, make sure that it is assembled firmly
NOTES:
1. The Non-removable Supply Holder is the one that slides in the wide slot while the Removable Supply Holder is the
one that slides in the narrow slot.
2. Do not turn the Supply Holder Locking Knob anti-clockwise too far, or it may come off the Supply Holder.