![background image](http://html.mh-extra.com/html/toshiba/b-480-qq/b-480-qq_owners-manual_429059013.webp)
E5-2
5. LOADING THE MEDIA
EO1-33008
5. LOADING THE MEDIA
4. Put the media on the supply shaft.
5. Pass the media around the damper, then pull the media towards the front of the printer.
6. Insert the ridge of the supply holder into the groove of the supply shaft until the media is fixed. Then turn
the locking ring clockwise to secure the supply holder. This will centre the media automatically.
NOTE:
Do not over tighten the locking ring of the supply holder.
7. Insert the media into the paper holders of the media guide, adjust the media guides to the media width,
and tighten the locking screw.
8. Check that the media path through the printer is straight. The media should be centered under the print
head.
NOTE: When using the label rolled with labels facing outside, please remove the upper plates of both
paper holders using the following procedure. Failure to do this may cause a paper jam error.
If you have any questions, please contact your nearest TOSHIBA TEC service representative.
Fig. 5-3
Fig. 5-4
Media
Paper Holder
Locking Screw
Media Guide
Media Guide
Supply Holder
Paper Holder
Print Head
Media
Media
Supply Holder
Supply Shaft
Damper
Groove Ridge
Projection
Summary of Contents for B-480-QQ
Page 1: ...TEC Thermal Printer B 480 QQ SERIES Owner s Manual ...
Page 28: ......
Page 29: ......
Page 30: ...PRINTED IN JAPAN EO1 33008 ...