EO1-33013
19
3.7 Self Test
To initiate the self test mode, depress the
FEED
button while turning on the
printer power. The printer will calibrate the label length. If the label gap is not
detected within 7", the printer stops feeding labels and the media is treated as
continuous paper. In self test, a check pattern is used to check the performance
of the thermal print head. Following the check pattern, the printer prints internal
settings as listed below:
1. Printer model and firmware version
2. Mileage
3. Flash times
4. Check sum
5. Serial port setting
6. Code page setting
7. Country code setting
8. Print speed setting
9. Print density setting
10. Label size setting
11. Gap (Bline) width and offset setting
12. Backing paper transparence
13. File list
14. Memory available
When the self test is completed, the printer enters the dump mode. Please turn
the printer's power off and then on to resume normal printing.
Summary of Contents for B-443
Page 1: ...TEC Bar Code Printer B 443 Owner s Manual ...
Page 5: ...EO1 33013 iii 5 2 Options 26 5 3 Supplies 27 5 3 1 Label Stock 27 5 3 2 Ribbon 27 ...
Page 14: ...EO1 33013 7 2 5 External Label Roll Mount Figure 4 External label roll mount ...
Page 23: ...EO1 33013 16 Figure 10 Installation of label stock and thermal transfer ribbon ...
