10
SETTING UP
Using the controls
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions
.
If the RED LED is unlit check that the mains plug is connected
to the power supply. If the picture does not appear press
1
on
the remote control, it may take a few moments.
To put the television into Standby press
1
on the remote
control. To view the television press
1
again. The picture may
take a few seconds to appear.
To set up the television you will now need to use the on-screen
menus. Press
M
on the remote control to see the menus.
The menu bar at the top of the screens will show five different
topics shown in symbols. As each symbol is selected by
pressing
Y
or
y
on the navigation ring on the remote control,
its respective options will appear below.
To use the options, press
<
on the navigation ring to move
down through them and
Q
,
Y
or
y
to select the required
choice. Follow the on-screen instructions. The functions of
each menu are described in detail throughout the manual.
To alter the volume press –
2
+.
To alter the programme position press
b
p
B
.
Press
MENU
and
I
,
i
,
U
or
u
to control the sound and picture
options.
Press
MENU
to finish.
To select the external input, press
o
until the appropriate
input source is selected as described on
page 23
.
Please always refer to the owner’s manual of the equipment to
be connected for full details.
Please note:
Inserting the headphone plug will mute the sound
from all speakers.
Standby
RED LED – Standby
GREEN LED – Power on
Headphone jack
Switching on
Using the remote control
Using the controls
00GB_AV500P_EngOM.book Page 10 Tuesday, December 11, 2007 5:40 AM
