Intr
oduction
Connecting
y
our T
V
Using the
Remote Contr
ol
Setting up
y
our T
V
Using the T
V
’s
F
eatur
es
Appendix
Index
14
32/36AFX61(E)
Programming the remote control for use with
your audio/video devices
Device code setup
1. Refer to the device code table on pages 16–19 to find the code for
the brand of your device.
If more than one code is listed, try each one separately until you
find one that works.
2. Repeatedly press MODE until the device mode indicator
(CABLE/SAT, VCR, DVD, AUDIO1, AUDIO2) lights up.
3. While holding down the RECALL button, press the Channel
Number buttons to enter the four-digit code for your device.
If a valid code is entered, the mode indicator will blink two times.
If an invalid code is entered, the mode indicator will blink one
long blink.
4. Point the remote control at the device and press POWER to test
the code.
If the device responds to the remote control, you have entered the
correct code.
If the device does not respond to the remote control, you may
have entered the wrong code. Repeat steps 3 and 4 using another
code.
5. To control the TV, repeatedly press MODE until the TV mode
indicator lights up.
Searching and sampling the code of a device (991)
If you do not know the device code for a particular target unit, you
can cycle the remote through the available codes for that device mode
and sample functions in order to find the code that properly operates
the desired target device. The keys available to be sampled, provided
they are applicable to that mode, are 0, 1, 2, 3, POWER, VOL
y
,
CH
y
, PLAY and STOP. Invalid keys will be ignored while in
program mode.
To cycle through each available device code and sample its functions:
1. Press MODE to select the mode you want to set up.
2. While holding down RECALL, press 9–9–1.
The remote control will enter program mode.
3. Point the remote control at the target device and press POWER
(or other function buttons that are available to be sampled).
4. If the device responds to the remote control:
Press RECALL to store the device code.
The mode indicator will blink two times and the remote
control will exit program mode.
If the device does not respond to the remote control:
Press
y
, and then press POWER.
Repeat this step until the device responds to the remote
control, and then press RECALL.
Note:
When a search cycle is complete, the mode indicator will blink three
times. The remote control will begin to cycle through the available codes
again. If no key is pressed within 10 seconds while programming, the
remote control will exit the program mode and return to the previous
code.
POWER
Channel
Numbers
RECALL
Note:
• Every time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2.” If
your VCR has this kind of switch and does
not respond to any of the codes for your
VCR brand, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
MODE
y
Summary of Contents for 32AFX61
Page 50: ......
