Toshiba 32A41, Owner'S Manual

Page: 31 / 35

31
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
2
If you want to watch the blocked program temporarily,
press
MUTE .
Press the
Channel
Number
buttons (0–9) to
enter your 4-digit PIN code.
If the number is correct, the
block mode will be
released.
After 1 second, the normal
picture will appear.
ENABLE BLOCKING : [Y]N
SET RATING
SET BLOCKING OPTIONS
NEW PIN CODE
BLOCK CHANNEL
MOVE[
t s
] SELECT[
T S
]
2
While in the V-CHIP
CONTROL menu, press
t
or
s
to select BLOCK
CHANNEL.
BLOCK CHANNEL
[SET]CLEAR
0 0 0 0
SELECT[
T S
] SET[
t s
]
END[EXIT]
BLOCK CHANNEL
[SET]CLEAR
0 0 0 2
SELECT[
T S
] SET[
t s
]
END[EXIT]
3
Press
T
or
S
to display the
BLOCK CHANNEL menu.
4
Press
T
or
S
to select
SET, and then press
t
or
s
until the channel number to
be blocked (“2” in this
example) replaces “0” in
the menu.
THIS PROGRAM HAS BEEN BLOCKED!
TV–PG L V
EXCEEDS SET LIMITS
PUSH MUTE TO ENTER PIN
CABLE 4
BLOCKING IS ACTIVE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~–
SELECT[0-9] END[EXIT]
INCORRECT PIN CODE
PLEASE ENTER PIN CODE
TO TEMPORARILY UN-BLOCK
~~~~
SELECT[0-9] END[EXIT]
All blocking is disabled until the TV is turned off,
and will be enabled when the TV is turned on again.
If a wrong PIN code is
entered, the message,
“Incorrect PIN Code”
appears. Enter the code
again. See page 28 for
details on entering the PIN
code.
Unblocking programs temporarily
1
If you try to watch a TV program that exceeds the rating
limits you set, the TV will enter into the program block
mode.
BLOCK CHANNEL function
You can use the BLOCK CHANNEL function to block
specific channels. You will not be able to tune blocked
channels unless you clear the setting.
You can block a maximum of 4 TV channels and 4 CABLE
channels.
To block channels:
1
Select the channel you want to block.
5
Repeat steps 1–4 for other channels.
6
Tune the TV to another channel before turning off the
TV or the TV will be on a blocked channel the next time
you turn it on.
To unblock channels:
1
Repeat steps 2– 4 above,
selecting CLEAR in step 4
(instead of SET).
2
Press
t
or
s
until “0”
replaces the channel
numbers (this unblocks all
blocked channels; you
cannot unblock individual
channels).
3
Press EXIT to clear the on-screen display.
BLOCK CHANNEL
SET [CLEAR]
15 10 6 2
SELECT[
T S
] CLEAR[
t s
]
END[EXIT]
0 0 0 0
Advanced Operation