11
Set up
Preparation
Basic Operation
Advanced Operation
Reference Section
Programming the remote control for use with
a non-Toshiba VCR or cable TV converter
1
Find the code for your brand of VCR or cable TV converter in the code
tables on pages 12–13.
If more than one code is listed, try each one separately until you find one
that works.
2
Set the
TV/CABLE/VCR
switch to VCR (for a VCR), or CABLE (for a
cable TV converter).
3
While holding down
RECALL
, press the
Channel Number
buttons to
enter the 3-digit code for your brand of VCR or converter.
4
To test the code, turn the VCR or converter on, point the remote control at
it, and press
POWER
.
–
If the correct code was entered
, the VCR or converter will turn off.
–
If the VCR or converter does not respond
, repeat steps 1–4 using
another code.
–
If the VCR or converter does not respond to a different code
, you
will need to use the remote control that came with your VCR or
converter.
5
Set the
TV/CABLE/VCR
switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR Code
Cable TV Converter Code
Note:
You must reprogram the remote control when you change the batteries.
Some newer VCRs respond to either of two codes. These VCRs have a switch
labeled “VCR1/VCR2.” If your VCR has this kind of switch and does not respond to
the codes for your VCR brand, set the switch to the other position (“VCR1” or
“VCR2”) and reprogram the remote control.
Your Toshiba TV remote control is preprogrammed to operate Toshiba brand VCRs and cable TV converters. To program
your TV remote control to operate a non-Toshiba VCR or a cable TV converter, follow these steps:
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL
MUTE
CH
CH
VOL
VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REW
PAUSE
FF
SOURCE
STILL
PIP
SLOW
PIP CH
LOCATE
SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEO
FAV CH
A
EXIT
RECALL
Channel
Numbers
POWER
Preparation
