1
. Place face down on soft surface
first. Begin by removing Stand – This
requires removal of 4 screws. Stand
must be removed to remove back
cover.
2
. Remove additional 24 screws to
complete back removal.
*Be sure to unplug manual
control cable as back is
removed.
*If shield over the Main Writing board
must be removed for service:
7 screws around cover
4 nuts around PC and Update
connectors
9 screws into jack assemblys
3
. To remove chassis assembly from display:
Remove 8 screws from sides of chassis
assembly.
Remove 4 screws into bezel at top and 4
at bottom.
2
2
2
2
4
4
4
. Finally, removed outlined plugs
and cabling, then lift chassis free of
bezel and display.
As this is done be sure to release
and unplug LVDS cable connected to
the panel control board.
5
. To remove display from bezel,
remove three screws in railing on
each side and set railing aside. Then
lift the display out of bezel.
LVDS
CONTROL
*IR/LED PCB must be
removed from bezel
32in. D
isassembly
7
