12
Programming the remote control to operate
your other devices
This remote control is pre-programmed to operate most Toshiba satellite
receivers, VCRs, and DVD players. To control a non-Toshiba device
(or a Toshiba device that the remote control is not pre-programmed to
operate)
1. Refer to the code tables (on pages 13 and 14) to find the
corresponding code for your device.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Press “CBL/SAT”.
• VCR: Press “VCR”.
• DVD player: Press “DVD”.
3. While holding down CODE, press the Channel Number buttons to
enter the three-digit code for your device within 10 seconds.
Note
: If you do not enter the code within 10 seconds from step 3, or
if you enter the wrong code, this operation is canceled.
4. Point the remote control at the cable TV converter/satellite receiver,
VCR or DVD player, and press POWER to test the code.
• If the device responds, you entered the correct code.
• If the device does not respond, repeat steps 1–4 using another
code.
5. Press “TV” to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite receiver code ______________________
VCR code _______________________________________________
DVD player code __________________________________________
Notes:
• When shipped from the factory, the remote
control is set to operate your TV.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled “VCR1/VCR2”.
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
Using the
Remote Control
CODE
To control a DVD player:
Program the remote
control to recognize the
brand of your DVD player
(see “Programming the
remote control to operate
your other devices”
below). The buttons
shown at right will then
control the DVD player.
Press “DVD” first.
Power
Number
buttons
DVD
TV
VCR
Input (TV)
Display
Mute (TV)
/– (TV)
Pic Size
DVD
DVD MENU
1
/
2
/
3
/
4
ENTER
DVD controls
DVD Skip/Search
J(
/
)K
Top Menu
DVD Clear
Channel
Numbers
CBL/SAT
J3V50121A(E)_P07-17.p65
30/06/2005, 5:07 PM
12
