NOTE 1:
When the unit is switched to the
monitor mode, EXT3 can be heard from the
speakers. When switched to this mode, the
VOL+/VOL- and MUTE buttons will be functional.
NOTE 2:
When the unit is in monitor mode, the
Stand-by button is functional. When the unit is
switched back on from the stand-by function, it
will open in the TV mode.
PC Mode MENU structure
When you press the ( ) button on your remote
control while the unit is in the PC mode,
the features available in the PC mode
will appear on screen as the PC MENU.
In order to make the necessary
adjustments in this menu, you can use
the right-left, up-down movement
(
)/(
)
,
( )/( ) buttons on your
remote control.
PHASE:
ADC’s phase setting
H.POSITION:
Horizontal position setting
V.POSITION:
Vertical position setting
AUTOMATIC CONFIGURATION:
The
most suitable geometric settings in
accordance to the entry mode is
configured by this function. For this application,
highlight the AUTOMATIC CONFIGURATION
option and press the OK button.
ENGLISH
-24-
Start Up
As your LCD-TV unit also enables VGA
applications, it can also be used as a PC monitor.
Switching to PC Mode
You can use PC button on your remote to switch
your LCD-TV to PC display mode. To switch back
to TV mode press the same button again.
Warning Messages:
1. NO SIGNAL:
There is no VGA connection.
Under these circumstances the on screen display
will be “NO SIGNAL”. The message will be on
screen for 15 seconds and if a suitable VGA
attachment is not made to the indicated area,
then the unit will switch itself to the POWER
SAVING mode in order to protect the unit panel.
2. OUT OF RANGE:
If the resolution application
is not one of the graphic entry modes, then the
on screen display will be “OUT OF RANGE”.
The message will remain on screen until the
necessary graphic entry mode is applied.
Important Cautions:
1. When a VGA mode is displayed for the first
time, an AUTOMATIC CONFIGURATION
application may be necessary.
2. According to the VGA power Saving
standards, when there is no signal, for 15 seconds
an on screen display of “NO SIGNAL” is shown
after which the unit switches itself off in a 3,5
Watt power saving mode.
If you switch to the monitor model after adjusting
the TIMER function available under the Special
Features menu, the timer function and program
switch will no longer function, however the
automatic shut-down application will continue
to function.
