Rev 3.0
D4161841C
14
(12)
Setting value memory
Each setting value can be saved in the memory inside the camera.
・The contents of the memory is held even after the power supply is turned off.
・The memory consists of 4 banks. For each table, you can save/readout the setting value independently, as well
as reset the setting value to the initial factory setting.
・You can set the number of the memory bank to be read out when the power supply is turned on, by using the
relevant dip switch on the back surface of the main body.
1) Memory save
Address：0x51, Bit：0 to 1, Value：0 to 3
・When you write to the register the number of the memory bank to which the setting value is to be saved, the
setting value of each register is saved in the internal memory.
・If you have not executed "Update" after changing the setting value (reset address 0x6E to 0x01), an execution
error occurs and the setting value is not saved in the memory. Be sure to execute "Update" before saving the
setting value.
2) Memory readout
Address：0x52, Bit：0 to 1, Value：0 to 3
・When you write to the register the number of the memory bank from which the setting value is to be read out,
the setting value is read out from the internal memory and set.
3) Memory reset
Address：0x53, Bit：0 to 1, Value：0 to 3
・When you write to the register the number of the memory bank to be reset, the initial factory setting value is
read out from the internal memory and set.
(13)
RAW Output bit
Address：0x90, Bit：0 to 1, Value：0 to 2
You can set gray scale per pixel. The initial factory setting is 12 bits.
(14)
Output format
Address：0x92, Bit：0, Value：0 to 1
You can set RGB(24bit) / RAW (12bit / 10bit / 8bit) output. The initial factory setting is RGB(24bit) output.
Summary of Contents for CleverDragon Series
Page 38: ...Rev 3 0 D4161841C 30 13 Outline Drawing ...
Page 39: ...Rev 3 0 D4161841C NOTE ...
