Rev 3.0
D4161841C
6
9. Functions
By accessing the camera register published on the camera link I/F, you can control/set each function.
Since access to the camera register is performed via the frame grabber board, the controlling and setting methods
differ depending on the frame grabber board you use. For details, refer to the instruction manual of the relevant
frame grabber board or contact our sales representative.
This instruction manual describes the specifications in the case where the camera register is directly connected by
serial transmission over the camera link interface.
9.1 Explanation of Each Function
(1) Register setting value updating
Address：0x6E, Bit：0, Value:1
The changed register setting value is reflected on the camera operation.
Only writing a value in each register does not cause the value to be reflected on the camera operation.
Register value updating must be executed before the changed setting value can be reflected on the camera
action.
To save the setting value in memory, the register setting value must be updated beforehand. Otherwise, an
execution error occurs and the setting value is unable to be saved in memory.
(2) Readout mode
Video is output from the camera link connector. The output video can be grabbed by the frame grabber board.
The frame rate and resolution of output images that this model supports are as follows:
1) All pixel readout
: Approximately 30 fps / 1628(H) x 1236(V)
2)
Partial scan
: Approximately 30 to 183 fps / 1628(H) x 552(V) to 1236(V)
3)
High-speed draft readout : Approximately 89 fps / 1628(H) x 309(V)
1)
All pixel readout
Address：0x70, Bit：0, Value:0 and Address：0x81, Bit：0, Value:0
Reads out all pixels in about 1/30 second.
FVAL
DATA OUT
LVAL
DVAL
1
2
3
4
5
6
7
8
1
2
3
6
1
2
3
5
1
2
3
4
1250H
Summary of Contents for CleverDragon Series
Page 38: ...Rev 3 0 D4161841C 30 13 Outline Drawing ...
Page 39: ...Rev 3 0 D4161841C NOTE ...
