5.
Swing the lever back over to tighten the baffle and cam
locks (
).
6.
If the cam locks do not lock the baffle into place or it is
too tight, loosen the lever and then rotate the cam lock.
Note:
Adjust the cam lock until the desired locking
pressure is achieved.
g027727
Figure 34
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments vary by grass type, moisture content, and the
height of the grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is as follows:
•
Short, light grass mowing conditions
•
Dry conditions
•
Smaller grass clippings
•
Propels grass clippings farther away from the mower
g005832
Figure 35
Position B
Use this position when bagging. Always align it with the
blower opening.
g005833
Figure 36
Position C
This is the full open position. The suggested use for this
position is as follows:
•
Tall, dense grass mowing conditions
•
Wet conditions
•
Lowers the engine-power consumption
•
Allows increased ground speed in heavy conditions
g005834
Figure 37
29
Summary of Contents for Z593-D Z Master 74264TE
Page 75: ...Schematics g012068 g012068 Wire Diagram Rev A 75 ...
Page 76: ...Notes ...
Page 77: ...Notes ...
Page 78: ...Notes ...