Maintenance
39
Installing the Blades
1.
Install the blade onto the spindle shaft (Fig. 20).
IMPORTANT: The curved part of the blade
must be pointing upward toward the inside of
the mower to ensure proper cutting.
2.
Install the spring disk and blade bolt. The spring
disk cone must be installed toward the bolt head.
(Fig. 20). Torque the blade bolt to 85–110 ft-lb
(115–150 N
m).
1
3
2
4
3
4
5
Figure 20
1.
Sail Area of Blade
2.
Blade
3.
Spring Disk
4.
Blade Bolt
5.
Cone Towards Bolt Head
Air Cleaner
Foam Element: Clean and re-oil after every 25
operating hours.
Paper Element: Replace after every 100 operating
hours.
Note:
Service the air cleaner more frequently
(every few hours) if operating
conditions are extremely dusty or
sandy.
Removing the Foam and Paper Elements
1.
Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
2.
Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage.
Unscrew the knob and remove the air cleaner
cover (Fig. 21).
1
2
m–3214
3
4
6
8
7
5
Figure 21
1.
Knob
2.
Air cleaner cover
3.
Cover nut
4.
Cover
5.
Foam element
6.
Paper element
7.
Rubber seal
8.
Air cleaner base
