47
Installing the Battery
1. Position battery in tray with terminal posts toward the
engine (Fig. 66).
2. First, install the positive (red) battery cable to positive
(+) battery terminal.
3. Then install negative battery cable and ground wire to
the negative (–) battery terminal.
4. Secure cables with 2 bolts (1/4 x 3/4 inch), 2 washers
(1/4 inch), and 2 locknuts (1/4 inch) (Fig. 66).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Secure battery with J-bolts, hold down clamp and
2 washers (1/4 inch), and 2 wing nuts (1/4 inch)
(Fig. 66).
1
9
5
2
6
7
10
4
3
8
11
7
m–5598
Figure 66
1.
Battery
2.
Terminal boot
3.
Positive battery cable
4.
Negative battery cable
5.
Ground wire
6.
Bolt, 1/4 x 3/4 inch
7.
Washer, 1/4 inch
8.
Locknut, 1/4 inch
9.
Battery clamp
10. J-bolts
11. Wing nut, 1/4 inch
Removing the Battery
Battery terminals or metal tools could short
against metal machine components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
•
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the machine.
•
Do not allow metal tools to short between the
battery terminals and metal parts of the
machine.
Warning
Incorrect battery cable routing could damage the
machine and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
•
Always Disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
•
Always Reconnect the positive (red) battery
cable before reconnecting the negative (black)
cable.
Warning
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Tilt seat up.
4. First disconnect the negative battery cable and ground
wire from the negative (–) battery terminal (Fig. 66).
5. Slide the red terminal boot off the positive (red) battery
terminal. Then remove positive (red) battery cable
(Fig. 66).
6. Remove both wing nuts (1/4 inch) securing the battery
clamp (Fig. 66).
7. Remove the battery.
Adding Water to the Battery
Note: Never fill the battery with distilled water while the
battery installed in the machine. Electrolyte could be
spilled on other parts and cause corrosion.
