Toro Z Master 74925TE, Operator'S Manual

Page: 20 / 72

G008959
1
2
Figure 15
1. On 2. Off
Operating the Ignition Switch
1. Turn the ignition key to the Start position
(Figure 16). When the engines starts, release the key.
Important:
Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 16
2. Turn the ignition key to stop to stop the engine.
Using the Fuel Shut-Off Valve
The fuel shut-off valve is located under the seat. Move
the seat as far forward as possible to gain access.
Close the fuel shut-off valve for transport, maintenance,
and storage.
Ensure the fuel shut-off valve is open when starting
the engine.
Figure 17
1. On 3. Hose going to the engine
2. Off
Starting and Stopping the
Engine
Starting the Engine
1. Raise the ROPS up and lock into place, sit on the
seat and fasten the seat belt.
2. Move the motion controls to neutral locked
position.
3. Set the parking brake; refer to Setting the Parking
Brake.
4. Move the blade control switch (PTO) to the Off
position (Figure 18).
5. Move the throttle lever midway between the Slow
and Fast positions.
20