Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right hand console next to
the seat (Figure 57).
2. To replace the fuses, pull out on the fuse to remove
it.
3. Install a new fuse (Figure 57).
Figure 57
1.
Optional accesory-15 amp
4.
Main-25amp
2.
Charge-25amp
5.
Console
3.
PTO-10amp
Drive System
Maintenance
Checking the Seat Belt
Service Interval:
Before each use or daily
Visually inspect seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace before
operating if damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval:
Before each use or daily
Check that both the mounting hardware and the knobs
are in good working condition. Make sure the knobs
are fully engaged with the ROPS in the raised position.
The upper hoop of the roll bar may need to be pushed
forward or pulled rearward to get both knobs fully
engaged.
41
Summary of Contents for Z Master 74923
