11
Checking the Seat Belt
International Machines Using
Gasoline Only
No Parts Required
Procedure
Important:
Ensure the bolt torque is set between
67 to 83 N∙m (49 to 61 ft-lb).
Check the seat belt angle and the seat belt bolt torque
before operating.
1.
Check the angle of the seat belt compared to
the bottom of the seat. The angle needs to be
47 degrees (
2.
If needed, set the seat belt to the correct angle.
3.
Check and set the bolt torque between 67 to 83
N∙m (49 to 61 ft-lb).
g014862
Figure 16
1.
Side of seat
3.
47 degrees
2.
Seat belt bolt, set torque
between 67 to 83 N∙m (49
to 61 ft-lb).
12
Installing the
Motion-Control Levers
International Machines Using
Gasoline Only
Parts needed for this procedure:
1
Right control lever
1
Left control lever
4
Bolt (3/8 x 1 inch)—2 are assembled
4
Nut (3/8 inch)—2 are assembled
Procedure
1.
Rotate the motion-control levers to the upright
position.
2.
Loosely install the control levers on the inside of
the posts using the 4 bolts and 4 nuts.
Note:
Install the control levers in the top and
middle holes for the high position or the middle
and bottom holes for the low position.
g009040
Figure 17
1.
Bolt (3/8 x 1 inch)
3.
Control lever
2.
Handle
4.
Nut (3/8 inch)
3.
Raise the levers and align them together in the
N
EUTRAL
position and tighten the bolts.
8
