Operation
17
Driving Forward or Backward
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place the
throttle control in the “FAST” position for best
attachment performance. Always operate in the full
throttle position when operating attachments.
Forward
1.
Release the parking brake; refer to Setting the
Parking Brake, page 13.
2.
To go forward, slowly push the motion control
levers forward (Fig. 9).
Note:
Engine will kill if motion control
levers are moved with parking brake
engaged.
To go straight, move both motion control levers the
same distance (Fig. 9).
To turn move the motion control lever to neutral, on
the side you want to turn toward (Fig. 9).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
Note:
The mowing speed reference position
can be felt as extra spring force when
pushing motion controls forward.
Motion control levers return to this
pre-set position, approximately 5 mph,
when forward pressure is reduced.
Below the pre-set speed the motion
control levers remain in their placed
location. For adjusting reference speed
refer to; Adjusting Mowing Speed
Reference Position page 32.
To slow or stop move the motion control levers to
neutral.
m–3288
3
4
2
3
1
2
5
5
4
5
5
1
Figure 9
1.
Motion control
lever-neutral position
2.
Forward
3.
Backward
4.
Slow
5.
Fast
Summary of Contents for Z-320
Page 7: ...Safety 5 Slope Chart Read all safety instructions on pages 2 4 ...
Page 38: ...Maintenance 36 Wiring Diagram ...
Page 43: ......
