Figure 36
1.
Dust cap
3.
Cotter pin
2.
Nut retainer
9.
Install the cotter pin and bend each legs around the
retainer (
).
10.
Install the dust cap onto the hub (
11.
Repeat steps
through
for the hub and rotor at the
other side of the machine.
Installing the Brakes and Wheels
1.
Clean the 2 flange-head bolts (3/8 x 1 inch) and apply
a coat for anti-seize compound to the threads of the
bolts.
2.
Align the brake pads to either side of the rotor (
) and the holes in the caliper bracket with the holes
in the brake mount of the spindle frame (
).
3.
Assemble caliper bracket to the spindle frame (
) with the 2 flange-head bolts (3/8 x 1 inch), and
torque the bolts 47 to 54 N-cm (35 to 40 ft-lb).
4.
Align the holes in the wheel to the studs of the hub
and assemble the wheel to the hub with the valve stem
outward (
).
Note:
Ensure the mounting surface of the wheel is
flush with the hub.
5.
Secure the wheel to the hub with the lug nuts (
), and torque the nuts to 108 to 122 N-m (80 to 90
ft-lb).
6.
Repeat steps
through
for the brake and wheel at the
other side of the machine.
Electrical System
Maintenance
Maintaining the Batteries
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
WARNING
Battery terminals or metal tools could short against
metal components causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
•
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the machine.
•
Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
•
Always keep the battery retainers in place to
protect and secure the batteries.
Cleaning the Batteries
Service Interval:
Every 25 hours
1.
Ensure that all of the battery caps are tight.
2.
Use a paper towel to clean the batteries.
3.
If the battery terminals are corroded, clean them with
a solution of 4 parts water and one part baking soda.
Also, clean the posts and cable clamps with a post and
clamp cleaner.
Note:
The posts and clamps should have a bright
metallic shine.
4.
Apply a light coating of Toro battery-terminal
protector.
32
