Toro Workman MDE 07299, Operator'S Manual

Page: 14 / 44

WARNING
Incorrect battery cable routing could damage
the machine and cables, causing sparks.
Sparks can cause the battery gasses to
explode, resulting in personal injury.
Always ensure the battery polarity when
making connections.
CAUTION
Batteries can give you a powerful electrical
shock.
• Use tools with plastic handles or wrap the
handles of metal tools with electrical tape.
• Be careful not to contact both a positive
terminal and a negative terminal at the
same time.
Figure 6
5. Install the battery retainers and torque the nuts to 17 to
22 N-m (150 to 200 in-lbs).
6. Connect the batteries together with the battery cables
included in loose parts (
Figure 6 ).
Important:
Check all high-current battery
connections to ensure that they have been properly
secured.
Note:
Ensure that the cable routing does not allow
cables to contact any sharp edges.
7. Tighten the bolt and secure the other side of the clip
with a new bolt (5/16 x 3/4 inch) and a flange nut
(5/16 inch) (
Figure 6 ).
8. Connect the long, red, main positive lead between the
bank of batteries and the machine (
Figure 6 ).
9. Connect the long, black, main negative lead between
the bank of batteries and the machine (
Figure 6 ).
WARNING
Loose or improperly secured battery
connections could damage the machine and
cables, causing sparks. Sparks can cause
the battery gasses to explode, resulting in
personal injury.
Always ensure the battery polarity when
making connections.
10. Torque the nuts securing all battery cables to 13.5 to 21
N-m (120 to 180 in-lbs).
11. Coat the battery terminals with Toro battery-terminal
protector.
12. Ensure that the rubber covers on each battery cable are
securely seated over the battery terminals.
3
Setting the Charger Voltage
Model 07299TC
No Parts Required
Procedure
Important:
The incorrect voltage setting on the battery
charger can impair function and damage the charger.
Always make sure that the charger voltage setting matches the
voltage used to power the charger.
1. Locate the voltage selector on the rear of the charger
(
Figure 7 ).
2. Adjust the voltage setting by moving the switch on the
voltage selector upward or downward to change the
voltage setting (
Figure 7 ).
14