Toro Workman HDX 07383, Operator'S Manual

Page: 40 / 68

g002373
Figure 36
1. Note the clearance between the fill device and the oil-fill
neck.
8. Install the dipstick firmly in place ( Figure 35 ).
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 200 hours
1. Raise the bed and place the safety support on
the extended lift cylinder to hold up the bed.
2. Remove the drain plug and let the oil flow into a
drain pan (
Figure 37 ).
g021292
Figure 37
1. Engine-oil-drain plug 2. Engine-oil filter
3. When the oil stops, install the drain plug.
4. Remove the oil filter ( Figure 37 ).
5. Apply a light coat of clean oil to the new filter
seal before screwing it on.
6. Screw the filter on until the gasket contacts the
mounting plate. Then tighten the filter 1/2 to 2/3
of a turn.
Note:
Do not overtighten.
7. Add the specified oil to the crankcase.
Responding to a Check-Engine
Light
Note:
Engine-fault code information can be accessed
by your Toro commercial products service staff only.
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Contact your Authorized Service Dealer.
40